What are the points for attention in plate bending machine operation?
Release time:
2020-02-18
Author:
Source:
In the manufacturing process of the bending machine, on the one hand, due to the complexity of the manufacturing process itself, on the other hand, due to the random changes in the manufacturing environment. The operator can only stand on both sides of the workpiece is a reasonable position.
In the manufacturing process of the bending machine, on the one hand, due to the complexity of the manufacturing process itself, on the other hand, due to the random changes in the manufacturing environment. The operator can only stand on both sides of the workpiece is a reasonable position. If in the process of operation, to adjust the measurement size roundness, then we must stop the operation, prohibit the operation in the process of operation. Bearing heating; Possible causes: 1. Incorrect installation. 2. Improper coordination, journal and hole wear. Elimination method: re-adjust correctly, check the lubrication and refueling, and replace the spare parts.
In daily cleaning, the plate bending machine is usually surrounded and entangled by fine objects such as hair and wool. The motor will suffer from greater torque due to higher load, which will cause the motor to have a fever. Over time, the surrounding entanglement will increase the battery load and affect the battery life. If it is severe, it will directly burn the motor. General manufacturers are equipped with cleaning tools. Cleaning the fuselage will affect the heat dissipation and cause the temperature to be too high. The safety pin in the safety coupling is cut off; possible cause: overload. Exclusion method: reduce the pressure of the upper roller and replace the new safety pin.
The belt, flywheel, gear and shaft of the bending machine are equipped with protective covers. Disconnect the switch of the bending machine and block the power supply. During the process of measuring the roundness of dimensions, the operator is prohibited from standing on the rolled cylinder, and at the same time, it is prohibited to stand on the workpiece to be processed. For some workpieces that are difficult to process: for example, thicker, or larger diameter, higher hardness or strength of raw materials, etc., a small amount of work should be done at the same time through many times to achieve the desired effect. For some workpieces with small diameter, they should be rolled in the middle of the roll for operation.
Key words:
Previous Page
Previous Page:
Next page:
Latest Developments
What are the areas of bending machine?
2024-10-22
How to detect the wear of rolling machine?
2024-10-22
