How to maintain the motor of the plate bending machine?
Release time:
2020-02-27
Author:
Source:
In the actual production process of the plate bending machine, it is inevitable that various system failures will cause the plate bending machine to fail to work normally. The general troubleshooting methods for plate bending include instrument measurement, interface signal inspection and PLC interruption state analysis with programmable controller. There are three troubleshooting methods.
In the actual production process of the plate bending machine, it is inevitable that various system failures will cause the plate bending machine to fail to work normally. The general troubleshooting methods for plate bending include instrument measurement, interface signal inspection and PLC interruption state analysis with programmable controller. There are three troubleshooting methods. Before work, check whether all parts of the plate bending machine are normal, whether the electrical equipment is in good condition, and whether the lubrication system is unblocked. Remove the sundries such as tools, measuring tools and corner wastes placed on the table top and its vicinity. The waste generated after operation is angular, and the operator should remove it in time to prevent being stabbed and cut.
Rolling bearing is the precision parts of the rolling machine, so it is required to be cautious when using it. The correct use can not only achieve the expected performance effect, but also prolong the running time of the rolling machine bearing and improve the service life. Reducer, it is the main component of the bending machine transmission, if used improperly, will present abnormal noise, noise is relatively large. The back cover of the head of the plate bending machine is actually composed of a gear, a rack and a stopper. The reciprocating movement of the back cover of the head on the horizontal plane is realized by the rack driven by the gear.
After the coil is finished, the power supply shall be closed in time, and the equipment shall be maintained and cleaned up on site. The position of the upper roller is fixed, and the lower roller moves upward and linearly to clamp the steel plate. Prevent the oil from squeezing into the electric idea due to high pressure during refueling, and splashing on the stator and rotor during operation, which will affect the heat dissipation function of the electric idea. The manufacturer of the plate bending machine should not only take timely remedial measures for the problems found in the inspection, but also tighten the screws and wiring of the motor according to the maintenance cycle, dismantle the inspection, clean and maintain, etc. For the normal operation of the rolling machine motor, the mechanic and maintenance electrician shall carry out maintenance once a year.
Key words:
Latest Developments
What are the areas of bending machine?
2024-10-22
How to detect the wear of rolling machine?
2024-10-22
